Exposure, contrast, highlights, shadows, whites and blacks
Color Light sets the light of a stretched image: Exposure, Contrast, Highlights, Shadows, Whites and Blacks, the Light section of Dark Room (All) in a panel of its own. A histogram above the controls follows every change, and Auto sets them from the image's levels.
The process is the Color Light section of Dark Room (All) on its own: it runs the same engine with every other control at no change, so its result is exactly what Dark Room (All) gives with the same settings and the rest at their defaults. With every control at its default the image comes out exactly as it went in.
Color Light is made for stretched images: the controls act on the values as they are, the way a photo editor acts on a picture. On a linear image the panel says so.
Figure: the Color Light panel, with the histogram, the Auto button and the controls.
The histogram of the image as the controls would make it is at the top, in red, green, blue and the luminance, and the controls follow it.
Auto: Sets Exposure, Contrast, Highlights, Shadows, Whites and Blacks from the levels of the image: the exposure that brings the middle gray to the middle of the range, the white and black points at the ends of the levels, and the shadows and highlights opened if they are crowded. Dark Room (All)'s Auto also sets Vibrance, which is in White Balance here.
Exposure: Brightens or darkens the whole image, from -5 to 5 stops, 0 by default. A stop is a doubling of the light of an image with a 2.2 gamma, so +1 multiplies every value by about 1.37. Values pushed past white are clipped unless Whites gives them room.
Contrast: From -100 to 100. Positive darkens the darker tones and brightens the brighter ones around the middle; negative flattens them.
Highlights: From -100 to 100. Positive brightens the bright tones, negative recovers them, leaving the dark ones.
Shadows: From -100 to 100. Positive brightens the dark tones, negative deepens them, leaving the bright ones.
Whites: From -100 to 100. Moves the white point. Positive makes the brightest tones white sooner (+100: everything from 0.75 up); negative gives them room, so that tones pushed past white by Exposure come back.
Blacks: From -100 to 100. Moves the black point. Positive lifts the darkest tones; negative makes them black sooner (-100: everything up to 0.15).
The tone is a smooth, rising function of the value: whatever the five sliders say, a darker value never comes out lighter than a brighter one.
The live preview (the eye at the end of the Applies to row) shows the result on the part of the image in view, as
Dark Room (All) does. What the whole image decides is measured once on the whole image, so the preview of a part is what
Apply gives there. Apply makes one history step that Undo takes back. Instance shows the process as text, a
DSPX process (.dsproc), to copy or save; the settings have the ids they have in Dark Room (All), so their
values mean the same in both. The process is our own and has no PixInsight icon.
Stretch first. The controls are made for the values of a stretched image.
Whites and Blacks before Highlights and Shadows. The two points set the ends of the range; the other two shape what is between them.
The tone curve. The curves are in Dark Room (All) alone, after these sliders.
Dark Room (All): every section in one panel, the tone curve included.
Histogram: the black point, the midtones and the white point by hand.
Curves: curves for the channels, the lightness and the saturation.